Functionalized magnesium-zinc surfaces for biodegradable implants: Nd:YAG machining and hot pressing approach

resumo

The design of a bio-absorbable load-bearing endosseous implant must ponder on different aspects, as an adequate absorption rate compatible with that of bone regeneration. During this biodegradation process it is necessary to maintain the material mechanical properties at a minimum level, while controlling the biodegradation products that although non-toxic in controlled amounts, can pose severe problems in increased quantities. This study explores the laser machining of pure magnesium (Mg) using a Nd:YAG laser through two distinct approaches to obtain grooves with different geometries. That are then aiming functionalized with zinc (Zn) by hot pressing technique, to control the dissolution rate. Groove morphology was shown to strongly depend on laser parameters, with round-bottom geometries (A3 and A4) enabling more uniform Zn filling. Dissolution testing in simulated body fluid revealed that Zn-functionalized grooves significantly reduced degradation, with Zn-A3 and Zn-A4 exhibiting degradation rates of 3.98 ± 0.02 and 1.12 ± 0.01 mg/cm²/h, respectively. In contrast, E1 showed rapid initial dissolution due to incomplete Zn integration.

autores

H. Pereira, S. Madeira, I. Costa, O. Carvalho, F.S. Silva, G. Miranda

nossos autores

Partilhe este projeto

Publicações similares

Usamos cookies para atividades de marketing e para lhe oferecer uma melhor experiência de navegação. Ao clicar em “Aceitar Cookies” você concorda com nossa política de cookies. Leia sobre como usamos cookies clicando em "Política de Privacidade e Cookies".