resumo
This work provides fundamental information regarding the technical, environmental, and economic viability of granite sludge valorisation as a substitute for feldspar in a ceramic paste and as a substitute for fine-medium inert in structural concrete.The granite sludge (GS) produced during block sawing can be exploited as alternative raw material in ceramic and concrete industries. Based on the case study of a Portuguese granite processing plant, this work analysed, by experimental tests and Environmental and Cost Life Cycle analyses, the feasibility of GS valorisation as a substitute (i) for feldspar in a ceramic paste and (ii) fine-medium inert filler in structural concrete. The results demonstrated that both the valorisation pathways are more advantageous than GS landfilling. Due to granulometric, mineralogical composition and shrinkage, GS can substitute feldspar in sandstone tiles or tableware products, although its tinting effect can limit noble whitish ceramic applications. In structural concrete mixes, 5% w/w GS instead of fine inert filler reduces the compressive strength and increases the water:cement ratio. The GS generates lower environmental impacts as a substitute for inert filler than as a substitute for feldspar in most of the impact categories analysed, even though the latter valorisation pathway provides higher benefits in Climate Change and the Depletion of Fossil resources, Water, and Ozone. If no monetary value is recognised for GS valorisation by the market, the sustainability of GS life cycle cost decreases when compared to its landfilling.
palavras-chave
CUTTING SLUDGE; BRICKS; WASTE
categoria
Chemistry; Engineering; Materials Science; Physics
autores
Surra, E; Sousa, J; Correia, M; Carvalheiras, J; Labrincha, JA; Marques, JC; Lapa, N; Delerue-Matos, C
nossos autores
João António de Sousa Carvalheiras
Estudante de doutoramento
João António Labrincha Baptista
Professor CatedráticoProjectos
CICECO - Aveiro Institute of Materials (UIDB/50011/2020)
CICECO - Aveiro Institute of Materials (UIDP/50011/2020)
Associated Laboratory CICECO-Aveiro Institute of Materials (LA/P/0006/2020)
agradecimentos
This work was financially supported by Portuguese national funds through projects UIDB/50006/2020, UIDP/50006/2020, and LA/P/0008/2020 from the Fundacao para a Ciencia e a Tecnologia (FCT)/Ministerio da Ciencia, Tecnologia e Ensino Superior (MCTES), and within the scope of the project CICECO-Aveiro Institute of Materials, UIDB/50011/2020, UIDP/50011/2020 and LA/P/0006/2020, financed by national funds through the FCT/MCTES (PIDDAC) and through the fellowship SFRH/BD/144562/2019.