abstract
Hydroxymethylfurfural (5-HMF) is a key platform chemical, essential for the production of other chemicals, as well as fuels. Despite its importance, the production methods applied so far still lack in sustainability. In this work, acidic deep eutectic solvents (DES), acting both as solvent and catalyst, were studied for the conversion of fructose into 5-HMF using microwave-assisted reactions. These solvents were screened and optimized by varying the hydrogen bond donor (HBD) and hydrogen bond acceptor (HBA). The bio-based solvent gamma-valerolactone (GVL) was also applied as additive, leading to a boost in 5-HMF yield. Then, a response surface methodology was applied to further optimize operating conditions, such as reaction time, temperature and wt.% of added GVL. The highest 5-HMF yield attained, after optimization, was 82.4% at 130 degrees C, in 4 min of reaction time and with the addition of 10 wt.% of GVL. Moreover, a process for 5-HMF recovery and DES reuse was developed through the use of the bio-based solvent 2-methyltetrahydrofuran (2-Me-THF), allowing at least three cycles of 5-HMF production with minimal yield losses, while maintaining the purity of the isolated 5-HMF and the efficacy of the reaction media.
keywords
IONIC-LIQUID; CATALYTIC CONVERSION; SOLID ACID; DEHYDRATION; BIOMASS; FRUCTOSE; FUELS; CHEMISTRY; GLUCOSE; SUGARS
subject category
Biochemistry & Molecular Biology; Chemistry
authors
Morais, ES; Freire, MG; Freire, CSR; Silvestre, AJD
our authors
Armando Jorge Domingues Silvestre
Full professor
Carmen Sofia da Rocha Freire Barros
Coordinating Researcher
Eduarda Serra Morais
Collaborator
Mara Guadalupe Freire Martins
Coordinating ResearcherGroups
G4 - Renewable Materials and Circular Economy
G5 - Biomimetic, Biological and Living Materials
Projects
CICECO - Aveiro Institute of Materials (UIDB/50011/2020)
CICECO - Aveiro Institute of Materials (UIDP/50011/2020)
Associated Laboratory CICECO-Aveiro Institute of Materials (LA/P/0006/2020)
acknowledgements
This work was developed within the scope of the project CICECO-Aveiro Institute of Materials, UIDB/50011/2020, UIDP/50011/2020 & LA/P/0006/2020, financed by national funds through the FCT/MEC (PIDDAC). E.S.M. acknowledges FCT/MCTES for the PhD grant [SFRH/BD/129341/2017]. FCT is also acknowledged for the research contracts under Scientific Employment Stimulus C.S.R.F. (CEECIND/00464/2017).