abstract
Three-dimensional (3D) printed poly(e-caprolactone) (PCL) based scaffolds have being proposed for different tissue engineering applications. This study addresses the design and fabrication of 3D PCL constructs with different struts alignments at 90 degrees, 45 degrees and 90 degrees with offset. The morphology and the mechanical behavior under uniaxial compressive load were assessed at different strain percentages. The combination of a new compressionCT device and micro computed tomography (micro-CT) allowed understanding the influence of pore geometry under controlled compressive strain in the mechanical and structural behavior of PCL constructs. Finite element analysis (FEA) was applied using the micro-CT data to modulate the mechanical response and compare with the conventional uniaxial compression tests. Scanning electron microscopic analysis showed a very high level of reproducibility and a low error comparing with the theoretical values, confirming that the alignment and the dimensional features of the printed struts are reliable. The mechanical tests showed that the 90 degrees architecture presented the highest stiffness. With the compressionCT device was observed that the 90 degrees and 90 degrees with offset architectures presented similar values of porosity at same strain and similar pore size, contrary to the 45 degrees architecture. Thus, pore geometric configurations affected significantly the deformability of the all PCL scaffolds under compression. The prediction of the FEA showed a good agreement to the conventional mechanical tests revealing the areas more affected under compression load. The methodology proposed in this study using 3D printed scaffolds with compressionCT device and FEA is a framework that offers great potential in understanding the mechanical and structural behavior of soft systems for different applications, including for the biomedical engineering field.
keywords
TISSUE ENGINEERING SCAFFOLDS; DRUG-DELIVERY DEVICES; FINITE-ELEMENT MODELS; POLYCAPROLACTONE SCAFFOLDS; POLYMER SCAFFOLDS; FABRICATION; ARCHITECTURE; DESIGN; TRENDS; PCL
subject category
Engineering; Materials Science
authors
Ribeiro, JFM; Oliveira, SM; Alves, JL; Pedro, AJ; Reis, RL; Fernandes, EM; Mano, JF
our authors
João Mano
Vice Directoracknowledgements
The author Fernandes E M acknowledges the financial support from the Portuguese Foundation for Science and Technology (FCT) and 'Programa Operacional Potencial Humano-POPH' and 'Fundo Social Europeu-FSE' for the post-doctoral grant (SFRH/BPD/96197/2013).