abstract
The performance of bimetallic copper-cerium oxides was investigated for the catalytic partial oxidation of methane. They were synthesized by two routes using either the intermetallic compound CeCu2 as catalytic precursor or the sol-gel method via cerium and copper nitrates (1:2) in the presence of urea. The catalysts prepared by the sol-gel method were always less active and selective than the catalyst prepared by the intermetallic route, which was comparable in catalytic behavior to noble metal catalysts on alumina (e.g. 5 wt% Rh/Al2O3, Cony. CH4 > 90%, Sel. H-2 > 99%, H-2/CO approximate to 2.0) at T= 750 degrees C. To our knowledge, this is a novelty for copper based catalysts. The copper-cerium oxide catalysts were also quite stable in the temperature range studied, 350-800 degrees C, and for a long period of time on stream. Such catalytic behavior seems to be determined by the surface morphology and composition and by an unusual interaction between the copper and cerium oxide that hinders the deactivation of the catalyst at high temperatures, which is a direct consequence of the synthetic method used in this work. Therefore, the bimetallic copper-cerium oxide catalyst obtained by the intermetallic route seem to be a good option to produce syngas with the advantage of being less expensive than the catalysts based on noble metals. (c) 2010 Elsevier B.V. All rights reserved.
keywords
CARBON-MONOXIDE OXIDATION; GAS-PHASE HYDROGENATION; SUPPORTED NI CATALYSTS; SOL-GEL PROCESS; CO OXIDATION; RAMAN-SPECTROSCOPY; TEMPERATURE OXIDATION; COMPOSITE CATALYSTS; METAL-OXIDE; IN-SITU
subject category
Chemistry
authors
Ferreira, AC; Ferraria, AM; do Rego, AMB; Goncalves, AP; Girao, AV; Correia, R; Gasche, TA; Branco, JB
our authors
acknowledgements
This work was supported by the Portuguese